Installation
Wipe wall with rubbing alcohol. Do not use household cleaners or water.
Plan your pattern by laying out panels on the floor. Verify you have the adequate wall space.
Designate a starting panel. This will be a guide for the rest of the patter.
Tip: We suggest using a panel that is in a corner of your design.
Tear apart strips and click them together.
Refer to placement guide here before starting these next steps! Peel the liner off one side.
Press firmly onto panel back following the placement guide. Always place on FSK backer only!
Repeat steps 4-6 for remaining strips on starting panel and any other panels in your design.
Measure and mark the placement for starting point. Using a level will ensure proper placement for remaining panels.
Peel off back liners for all strips on starting panel.
Use guide line to place panel against wall and press firmly for 30 seconds.
Repeat steps 9&10 for each remaining panel. Use the already mounted adjacent panel as a guide.
Tip: By butting up an edge to a panel already mounted, you can swing the panel on that pivot point to ensure proper placement.
Once all panels are mounted, remove each gently by swinging up and away from the wall.
Press strips into the wall for 30 seconds. Wait 1 hour to let adhesive set.
After 1 hour, repeat steps 10 & 11 again, firmly pressing panels until you hear strips click together.
Tip: Use a level again with the first panel to ensure proper placement.
Enjoy your new acoustically treated space! Sing a song! Do a little dance! Maybe even post a picture on Instagram using #setthetono and tagging us @shop.tono.
Placement Guide
This is to be used as reference for strip placement on tiles. Locations are generalized and the diagrams are not necessarily to scale. Remember: always place strips on FSK backer, never on fabric or painted layer that is folded onto the back.
